Valet Take-Over; Power Saver Mode - Directed Electronics 474A Manual Del Usuario

Valet take-over

The Valet Take-Over feature allows the vehicle to remain running after
the key has been removed from the ignition. This feature is useful for
occasions when you wish to exit and lock the vehicle for short periods
of time, but would like to leave the motor running and the climate
controls on.
To perform Valet Take-Over:
1. Before turning off the engine, press and release
control (or press and release the optional momentary switch). Then
wait ive seconds.
2. Turn the ignition key to the OFF position. (The engine will stay run-
ning.) The engine will run until the pre-programmed time elapses
or a shut-down input is received. (See the previous Remote Start
section for a complete list of shut-down inputs.)
This feature will not work if the brake pedal is being pressed.

Power saver mode

Your system will automatically enter Power Saver Mode while armed/
locked or in Valet Mode, after a period of time in which no operation
has been performed. For more information, please refer to the expand-
ed version of this manual online at www.automatecarsecurity.com
20 © 2010 Directed Electronics. All rights reserved.
on the remote