Installing Batteries in the Remote Control
1. Slide the cover out completely.
2. Install two AAA size batteries.
3. Replace the cover.
If the remote control doesn't work, check the following:
1. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power outage, or is the power cord unplugged?
5. Is there a special fluorescent light or neon sign nearby?
Switching On and Off
The mains lead is attached to the rear of your set.
1. Plug the mains lead into an appropriate socket.
The standby indicator lights up on the front of the set.
2. Press the POWER
button on the front of the set.
The programme that you were watching last is reselected automatically.
3. Press the numeric button (0~9) or channel up/down (
button on the right side of the set.
When you switch the set on for the very first time, you will be asked to choose language in which the menus
are to be displayed.
4. To switch your set off, press the POWER
Placing Your Television in Standby Mode
Your set can be placed in standby mode in order to reduce the power consumption. The standby mode
can be useful when you wish to interrupt viewing temporarily (during a meal, for example).
1. Press the POWER
button on the remote control.
The screen is turned off and a red standby indicator appears on the front of your set.
2. To switch your set back on, simply press the POWER
up/down (
/
) button again.
Do not leave your set in standby mode for long periods of time (when you are away on holiday, for example).
It is best to unplug the set from the mains and aerial.
Plug & Play
All manuals and user guides at all-guides.com
Make sure to match the "+" and "–" ends of the batteries with the diagram inside the compartment.
Remove the batteries and store them in a cool, dry place if you won't be using the
remote control for a long time. The remote control can be used up to about 23 feet from
the TV. (Assuming typical TV usage, the batteries last for about one year.)
button again.
When the TV is initially powered on, several basic settings proceed
automatically and subsequently. The following settings are available.
1. Press the POWER
The message "Plug & Play" is displayed.
2. Select the appropriate language by pressing the
Press the ENTER
3. The message "Check antenna input." is displayed with "OK" selected.
Press the ENTER
Please check that the antenna cable is connected correctly.
English-6
/
) button on the remote control or
, numeric buttons (0~9) or channel
button on the remote control.
button to confirm your choice.
button.
or
button.