Symmons Origins 9603-PLR Manual De Funcionamiento Y Mantenimiento página 4

Installation
Note:
For valve body installation, please
see valve body manual.
1) Install shower escutcheon (E) to
shower valve. Secure with two
screws (D).
E
D
2) Install dome cover (C) to valve by
turning clockwise.
C
3) Install handle (A) to valve. Secure
with set screw (B).
A
B
Note: Handle should be facing the
6 o'clock position.
4) Install tub spout (M) to pipe fitting.
Turn clockwise to secure.
M
5) Remove slide bar ends (H1) from
slide bar flanges. Using flanges
as a guide, drill 1/8" pilot holes
into studs or wood blocking.
With slide bar (H) in position,
secure to wall using screws (G).
Attach slide bar ends (H1) to bar
flanges.
G
H1
Note: Slide bar must be secured
with at least two of the three
screws (G) at each end.
6) Disassemble slide assembly (J).
2
J4
H
J1
J2
J3
4
7) Install slide assembly (J) to slide
bar (H). Flat edge on (J2) and (J3)
must be aligned. Arrows on (J2)
and (J4) indicate bottom side.
J1
J2
SLIDE
J4
LOCK
SLIDE
Note: Adjust screw cap (J1) for ease
of movement of slide assembly.
8) Press tabs on wall ell flange and
install wall ell (I) to pipe fitting.
Turn clockwise to secure.
I
9) Attach hand shower (F) to hose (L).
Attach hose (L) to vacuum breaker
(K). Connect vacuum breaker (K) to
wall ell (I). Turn clockwise to tighten.
F
L
H
J3
1
1
I
K
L