Cooper Lighting SURE-LITES CCX Serie Instrucciones Para La Instalación

SURE-LITES
Installation Instructions For CC-3, CC-4 and CC-5 Self Diagnostic
Units Emergency Lighting Fixtures
IMPORTANT SAFEGUARDS
WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS
BE OBSERVED INCLUDING THE FOLLOWING:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1.
2. Do not use outdoors.
3. Do not mount near gas or electric heaters.
4. Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized
personnel.
5. The use of accessory equipment not recommended by Sure-Lites may cause an unsafe condition.
6. Do not use this equipment for other than its intended purpose.
7. Some equipment covered by these instructions are rated for remote heads. This equipment does not require a load fuse because its
sophisticated solid-state transfer switch is current limited. Check load rating of equipment to calculate remote capability. DO NOT
exceed TOTAL OUTPUT RATING of equipment. TRANSFER CIRCUIT will automatically shut down if overloaded.
SAVE THESE INSTRUCTIONS
8.
INSTALLATION
Step 1. De-energize the circuit at the junction box (J-box) where the exit sign is
to be installed.
Step 2. Extend unswitched 24 hour AC supply of rated voltage frorm the J-box.
Use the black, orange, and white extension leads and wire nuts provid-
ed. Determine the line voltage to be supplied to the exit and follow the
instructions in the table below.
Line voltage to J-box 120V
Be supplied line
120 Volts Extend using
the black lead
277 Volts N/A
Step 3. Thread the extension leads through the backplate wire pass hole and
securely mount the backplate to the J-box.
Step 4. Using the backplate clips route the extension leads to the appropriate
push-in connector per the schematic.
Step 5. Trim and strip (strip length .375) any excess wire allowing enough slack
to insert the stripped ends into the appropriate push-in connector.
Step 6. Insert the wires into the appropriate push-in connector.
Step 7. Adjust heads to the desired position.
Step 8. Connect the battery using the red and blue leads originating from the
circuit board. ( Red lead to the "+" terminal, blue to the "-").
Step 9. Snap the tether straps over the integral posts in the backplate.Rest the housing against the wall.
Step 10. Mate the plug assembly.
Step 11. Snap the housing onto the backplate.
Step 12. Adjust heads to the desired position.
CONTINUED NEXT PAGE
J-box 277V
line
N/A
Extend using
the orange lead
SURE-LITES 1121 HWY 74 SOUTH PEACHTREE CITY, GA 30269 770-486-4800 FAX 770-486-4801 8/03
J-box Neutral
line
Extend using
the white lead
HOUSING
Extend using
the white lead
CCX Series
BACKPLATE
BATTERY
PATENT PENDING
PLUG
ASSEMBLY
STRAP
024000049E