Product Description; Initial Operation - Renfert SILENT TC Guia De Inicio Rapido

Product Description

Component Groups and Functional Elements
See Fig. 1 (on inside cover)
1
SILENT TC
2
Control panel
3
On / off switch
4
Dust drawer
4a Clamp fastener
5
Fine filter
6
Suction port
See Fig. 2 (on inside cover)
3
On / off switch
20 Display Automatic operation
21 Start operation key, Automatic / continuous
operation
22 Display continuous operation
23 [-] key (reduce value)

Initial Operation

Setting-up
The suction unit is a standing device which must not be operated in a horizontal position.
If the suction unit is placed in a closed cabinet, the warm exhaust air must be transported out of
the cabinet using one of the measures shown in Figs A, B, C at the start of this manual.
A: External exhaust air duct (see accessories at www.renfert.com).
B: Opening in cabinet rear panel, specified dimensions, observe the minimum and maximum
measurements.
C: Remove the back panel of the cabinet, distance from the back of the cabinet to the wall min. 50 mm.
Connect
Warning risk of injury!
When shortening the suction tube, please be sure to cut the integrated wire as straight as possi-
ble.
Long suction tubes, tight bends and kinks greatly reduce the suction power at the suction point.
⇒ Shorten the suction tube if possible.
⇒ Open the adhesive strap (7).
⇒ Plug the suction tube end piece (12) into the suction socket (6).
⇒ Fix the suction tube in place with the adhesive strap.
⇒ Connect the suction tube to the correct suction point.
If the diameter is not suitable, use an adapter (see accessories), to avoid loss of suction.
⇒ Connect the electronic device to the appliance socket (8) on the back.
When connecting electrical appliances to the suction unit, ensure that the maximum permissible
power for connected devices is not exceeded (see "Technical data" at the end of this document).
⇒ Switch the device off at the on / off switch (3).
⇒ Unroll the power cord (9) and insert the power plug into the building wall socket.
7
Velcro® strip
8
Device socket
9
Mains cable
10 Protective device switch (2 x)
11 Exhaust air filter / Exhaust air outlet
12 Suction hose
24 Display
25 [+] -key (increase value)
26 Display empty dust drawer
27 Enter key, save input
28 Cover (do not remove, service interface)
- 3 -
EN