Care And Cleaning - Monogram ZES1227SLSS El Manual Del Propietario

CARE AND CLEANING

HELPFUL HINTS
An occasional thorough wiping with a solution of baking
soda and water keeps the inside fresh.
HOW TO CLEAN THE INSIDE
Walls, Floor, Inside Window, Metal and Plastic Parts
on the Door
Some spatters can be removed with a paper towel; others
may require a damp cloth. Remove greasy spatters with
a sudsy cloth, then rinse with a damp cloth. Do not use
abrasive cleaners or sharp utensils on oven walls.
To clean the surface of the door and the surface of the
oven that come together upon closing, use only mild,
nonabrasive soaps or detergents
using a sponge or soft cloth.
Rinse with a damp cloth and dry.
Never use a commercial oven
cleaner on any part of your
microwave.
HOW TO CLEAN THE OUTSIDE
Do not use cleaners containing ammonia or alcohol on
the microwave oven. Ammonia or alcohol can damage the
appearance of the microwave.
Case
Clean the outside of the microwave with a sudsy cloth.
Rinse with a damp cloth and then dry. Wipe the window
clean with a damp cloth.
Control Panel and Door
Wipe with a damp cloth. Dry thoroughly. Do not use cleaning
sprays, large amounts of soap and water, abrasives or sharp
towels can also scratch the control panel.
Door Surface
It is important to keep the area clean where the door
seals against the microwave. Use only mild, non-abrasive
detergents applied with a clean sponge or soft cloth.
Rinse well.
49-40781 Rev. 3
Be certain the oven control is turned off before cleaning
any part of this oven.
Removable Turntable and Turntable Support
To prevent breakage, do not place the turntable into water
just after cooking. Wash it carefully in warm, sudsy water or
in the dishwasher. The turntable
and support can be broken if
dropped. Remember, do not
operate the oven without the
turntable and support in place.
Power Cord
If the cord becomes soiled, unplug and wash with a damp
cloth. For stubborn spots, sudsy water may be used, but
be certain to rinse with a damp cloth and dry thoroughly
before plugging cord into outlet.
Stainless Steel (on some models)
Do not use a steel-wood pad; it will scratch the surface.
To clean the stainless steel surface, use a hot, damp cloth
with a mild detergent suitable for stainless steel surfaces.
Use a clean, hot, damp cloth to remove soap. Dry with a dry,
clean cloth. Always scrub lightly in the direction of the grain.
19