Graco 06442-41 Serie Instrucciones De Montaje página 3

1.1
Position the left arm assembly (C-L)
to the glider base (A).
Lift up Velcro on the side of left arm
1.2
assembly to expose holes.
1.3
Attach left arm assembly (C-L) to
glider base (A) using bolts (2) with
spring washer (3) through the holes
of the left arm assembly (C-L)
1.4 Use Allen key (4) to fasten but do
not fully tighten bolts to allow easier
assembly of back frame (B).
1.5
Repeat steps 1.1 to 1.4 to assemble
the right arm assembly (C-R) to
glider base.
2.1
Position back frame (B) between left and right
arm assemblies (C-L and C-R).
2.2
Attach back frame (B) to glider base (A) using 2
bolts (2) with spring washers (3).
2.3
Use Allen key (4) to fasten but do not fully
tighten bolts.
2.4
Attach left and right assemblies (C-L and C-R)
to the back frame (B) using 2 bolts (1) with
spring washers (3) through the holes of the back
frame (B).
2.5
Use Allen key (4) to fasten bolts.
2.6
Tighten all bolts of back frame (B) and arms
assemblies C-L and C-R.
NOTE: REGULARLY CHECK
AND RETIGHTEN ALL
ASSEMBLY BOLTS.
STEP 1
GLB
STEP 2
3