Set-Up - HAMPTON BAY 50400143 Guía Para El Uso Y Cuidado

Set-up

1
Assembling the Umbrella
□
Align the push button at the end of the umbrella (1) with
the hole at the top of the lower umbrella pole (2).
□
Press the push button (3) and insert the umbrella into the
lower umbrella pole until the push button locks.
□ If your model shipped with the solar panel (4) packed
separately (not attached to the umbrella), mate the
electronic connector from the solar panel with the
electronic connector located at the top of the umbrella (5).
Then insert and twist the solar panel into the top cap
to lock.
□
Place the umbrella upright in a heavy weighted stand (not
included), and table capable of firmly securing the
Umbrella.
1
CAUTION: Do not insert the end of the umbrella pole into
Do not attempt to alter the wiring or operate
the ground. The solar umbrella Is designed to be used with
an umbrella stand (not included).
4
3
2
2
Adjusting the Umbrella Up & Down
□ Using the crank handle (2), raise the umbrella to desired
height. Turn the crank handle (2) clockwise to open the
umbrella.
□
Insert the locking pin (1) through both adjustment holes
to secure.
1
NOTE: Select adjustment holes immediately below
the base of the umbrella.
3
Adjusting the Umbrella Tilt
5
□ Hold the umbrella pole (1) above the tilt button, and press
the tilt button (2) inward.
□
With the tilt button pushed inward, move the umbrella to
the desired position, then release the button to lock in
place.
4
2
2
1
1