Set-Up - HAMPTON BAY 50400143 Guía Para El Uso Y Cuidado

Set-up (continued)
4
Charging the Battery using the USB
Power Adapter
□
Loosen screws (1) securing the battery pack (2) to the crank housing.
□
Carefully lift the battery pack from the crank housing
compartment.
□
Connect the micro USB cable (a) to the micro USB charging
port (b) on the back of the battery pack.
□ Connect the USB plug end of the cable to a powered USB port
on a computer or other USB charging device (not included).
A steady Red light (c) indicates the battery is charging and
steady Green light when unit is fully charged.
WARNING:
Use product with supplied 3.2v - 3.7v / 4000maH
LiFePo battery pack only. Use of any other batteries may create
a risk of fire.
NOTE:
Before operating, the batteries need to be fully charged.
The batteries may require up to 8-hours of full sunlight and/or
charging device (not included) to fully charge.
5
Charging the Battery using the Solar Panel
□ Place the fully assembled solar umbrella in full sun where it
will receive direct sunlight for at least 8 hours per day.
NOTE: The number of hours of LED light output and sound
output is directly proportional to the number of hours of
sunlight it receives. The solar panels cannot recharge the
batteries if light is obstructed. Use a USB Power Adapter
(not included) in low or obstructed light locations.
NOTE:
For first time use, charge unit for about 8 hours. USB
charging device (power adapter) with a rated output of between
1 – 7.5 Watts is recommended. The lower the output the longer it
will take to charge battery.
1
5
Please contact 1-855-HD-HAMPTON for further assistance.
2
c
3
b
a
HAMPTONBAY.COM