Signature SKSDV3002 Manual Del Propietário página 42

42 MAINTENANCE
7
Turn the upper or lower Oven Mode knob to
select the Clean mode. Then select SpeedClean
in the display.
8
Touch Start. The remaining time appears in the
display.
CAUTION
• Some surfaces may be hot after the
SpeedClean™ cycle. Wear rubber gloves while
cleaning to prevent burns.
• During the SpeedClean™ cycle, the oven
bottom becomes hot enough to cause burns.
Wait until the cycle is over before wiping the
inside surface of the oven. Failure to do so may
result in burns.
• Avoid leaning or resting on the oven door glass
while cleaning the oven cavity.
9
A tone will sound at the end of the 10-minute
cycle. turn the UPPER or LOWER Oven Mode
knob to the OFF position to clear the display
and end the tone.
10
After the cleaning cycle and during hand-
cleaning, enough water should remain on the
oven bottom to completely submerge all soils.
Add water if necessary. Place a towel on the
floor in front of the oven to capture any water
that may spill out during hand-cleaning. If you
are cleaning the upper oven on a double oven,
it is also best to cover the holes in the top of
the lower oven door with a towel to capture
any water that may drip into the door during
hand-cleaning.
11
Clean the oven cavity immediately after the
SpeedClean™ cycle by scrubbing with a wet,
non-scratch scouring sponge or pad. (The
scouring side will not scratch the finish.) Some
water may spill into the bottom vents while
cleaning, but it will be captured
in a pan under the oven cavity
and will not hurt the burner.
NOTE
DO NOT use any steel scouring pads, abrasive
pads or cleaners as these materials can
permanently damage the oven surface.
12
Once the oven cavity is cleaned, wipe any
excess water with a clean dry towel. Replace
racks and any other accessories.
13
If some light soils remain, repeat the above
steps, making sure to thoroughly soak the
soiled areas. If stubborn soils remain after
multiple SpeedClean™ cycles, run the Self
Clean cycle. Be sure that the oven cavity is
empty of oven racks and other accessories,
and that the oven cavity surface is dry before
running the Self Clean cycle. Consult the Self
Clean section for further details.
NOTE
• If you forget to saturate the inside of the oven
with water before starting SpeedClean™,
turn the or lower Oven Mode knob to the OFF
position to end the cycle. Wait for the oven
to cool to room temperature and then spray
or pour water into the oven and start another
SpeedClean™ cycle.
• The cavity gasket may be wet when the
SpeedClean™ cycle finishes. This is normal.
Do not clean the gasket.
• If mineral deposits remain on the oven bottom
after cleaning, use a cloth or sponge soaked in
vinegar to remove them.