Washer And Dryer Safety; Tools And Parts; Installing Card Reader-Single Tl Washer, Matching Dryer; And Csp - Whirlpool CHW9160GW Instrucciones De Instalación

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
DANGER
WARNING
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
■ TORX T20 Security driver
†
■ Adjustable wrench

INSTALLING CARD READER-SINGLE TL WASHER, MATCHING DRYER,

INSTALLING CARD READER-SINGLE TL WASHER, MATCHING DRYER,
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1� Unplug washer or dryer or disconnect power.
2� Place a protective covering, such as a towel or a work pad,
on top of the washer or dryer.
3� For single washers or dryers, remove the 4 top control panel
security TORX screws. For stacked dryers, remove the
6 control panel screws.
†TORX and T20 are trademarks of Acument Intellectual
Properties, LLC.

WASHER AND DRYER SAFETY

Your safety and the safety of others are very important.

TOOLS AND PARTS

TOOLS AND PARTS
■ Card reader
■ Phillips screwdriver
You can be killed or seriously injured if you don't immediately
follow instructions.
You can be killed or seriously injured if you don't follow
instructions.
Parts supplied in Kit
Check that all parts were included.
■ Bezel
■ Harness

AND CSP

AND CSP
4� Lay the control panel face down onto the top of the washer
or dryer.
5� Remove the screw from the center of the retainer.
■ Phillips head screws (3)
Note: Screws may be pre-
installed on some models.
■ Nuts (6)
Note: Three nuts may
be pre-installed on some
models.
A. Security TORX screws
A. Screw B. Retainer
A
A
B
2