Whirlpool CAE2761KQ0 Guia De Inicio Rapido

WHIRLPOOL COMMERCIAL ONL WHIRLPOOL COMMERCIAL ONL WHIRLPOOL COMMERCIAL ONL Y Y Y Y Y
WHIRLPOOL COMMERCIAL ONL WHIRLPOOL COMMERCIAL ONL
KITCHEN PRODUCTS
ADVANTECH™ and EMS1000 WASHERS AND DRYERS
WASHER MODELS
CAE2761KQ0
CAE2762KQ0
CAE2792KQ0
ALL CAP2761 AND CAP2762
CONDITION:
The cycle does not complete, or the cycle resets and vend
price shows when the washer finishes filling or the dryer
gas valve cycles.
CAUSE:
The suppressor on the line in or the quencher is not oper-
ating or has been removed.
ADVENTECH™ CONTROL
COMMERCIAL POINTERS: www.whirlpoolcorp.com/cltpsc, TECHNICAL INFORMATION, SERVICE POINTERS
LAUNDRY PRODUCTS
ELECTRIC DRYER MODELS
CEE2760KQ0
CEE2790KQ0
CEP2760KQ0
CSP2770KQ0
REFRIGERATION PRODUCTS
GAS DRYER MODELS
RESOLUTION:
Inspect the washer or dryer for installation of the quencher
and the suppressor as described on the following page.
The suppressor assembly is designed to absorb line spikes
to prevent damage to the electronic control. Some spikes
are above the ability of the suppressor to absorb and cause
supressor or control failure. Visually inspect the suppres-
sor for signs of discoloration. In the event that the line
filter MOV within the suppressor fails as indicated by the
MOV turning from red to black, the board should be in-
spected for evidence of damage. Replace suppressor with
part number indicated in the suppressor /quencher table.
Replace the board if there is extensive discoloration in the
illustrated areas combined with erratic operation.
EMS1000 CONTROL
L8178238 L8178238 L8178238
L8178238 L8178238
September 2002 September 2002
September 2002 September 2002 September 2002
Remove & destroy Remove & destroy Remove & destroy Remove & destroy Remove & destroy
pointer L8178046 pointer L8178046
pointer L8178046 pointer L8178046 pointer L8178046
dated September 2001 dated September 2001
dated September 2001 dated September 2001 dated September 2001
CGE2761KQ0
CGE2791KQ0
CGP2761KQ0
CSP2771KQ0
(continued)