Campbell Hausfeld PW1345 Instrucciones De Montaje

Assembly Instructions and Parts List
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or prop-
erty damage! Retain instructions for future reference.
Specifications
Max Pressure with
Model Standard Lance
PW1345 1300 psi
PW1346 1300 psi
PW1350 1300 psi
PW1375 1300 psi
PW1376 1300 psi
Assembly Instructions
Figure 1
Garden Hose Connection
GARDEN HOSE CONNECTION
INSTRUCTIONS
1. Attach nipple adapter to inlet fit-
ting on the unit (this may already be
attached to the pump).
2. Attach quick connect fitting to
garden hose.
3. Pull side "A" of quick connect fit-
ting toward garden hose and push
onto nipple adapter.
© 1999 Campbell Hausfeld
PW1345, PW1346, PW1350 , PW1375, and PW1376
Effective Pressure Maximum
w/Turbo Lance Capacity
— 1.8 GPM
— 1.8 GPM
— 1.8 GPM
1750 psi 1.8 GPM
1750 psi 1.8 GPM
4. Push side "A" of quick connect fit-
ting towards nipple adapter and
release.
"A"
Nipple
Adapter
Figure 2 - Garden Hose Connection
For parts, product & service information
visit www.campbellhausfeld.com
Electric Pressure
Washer
NOTE: REFER TO PRODUCT MANUAL FOR
ALL SAFETY INSTRUCTIONS
Motor Power
(Single Phase)
13 Amps
13 Amps
13 Amps
13 Amps
13 Amps
Quick Connect Fitting
Garden Hose
Maximum Inlet
Voltage Water Temperature
120V 100˚F
120V 100˚F
120V 100˚F
120V 100˚F
120V 100˚F
! IMPORTANT !
This pressure washer maybe
equipped with a microswitch sensi-
tive to water flow. This Instant
Start/Stop switch (ISS) senses water
flow in the pump. When the trigger
is released, water stops flowing
through the pump. The ISS then
automatically turns the motor off to
protect pump from overheating.
OPERATION
1. Turn the "ON/OFF" switch to
"ON".
2. Pull trigger on gun to begin
spraying water.
3. Release trigger. The pressure
washer motor will stop running.
4. To spray again, pull trigger and
motor and pump will restart.
Note: Occasionally the motor may
run for a short time to bring fresh,
cool water into the pump even if
trigger is released. This is part of
normal operation and will not dam-
age the unit.
Always turn the
"ON/OFF" switch
to "OFF" then trigger gun to release
hose pressure before unplugging
power cord.
Risk of Injection.
Unit will start
spraying when trigger is squeezed if
on/off switch is in "ON" position.
Always point gun in safe direction.
Call 1-800-330-0712
for Technical Service
Approved
IN456800AV 10/99
U L
#7P64
Unit
Weight
25 lbs.
25 lbs.
25 lbs.
25 lbs.
25 lbs.