Campbell Hausfeld STANDART DUTY PW1676 Guia De Inicio Rapido

Assembly Instructions and Parts List
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or prop-
erty damage! Retain instructions for future reference.
Specifications
Max Pressure with
Model Standard Lance
PW1676 1300 psi
Installation Instructions
Tools Required for Installation:
Flat Screwdriver
Hammer/Mallet
Adjustable Wrench
1. Set plastic spacer (included in parts
pack) on workbench (Figure 1).
Figure 1
2. Place "star shaped" retaining ring on
the spacer (tangs pointing down)
(Figure 2).
Figure 2
3. Tap the retaining ring onto the axle
(Figure 3 & 4).
Figure 3
© 2000 Campbell Hausfeld
Effective Pressure Maximum
w/Turbo Lance Capacity
1750 psi 1.9 GPM
Figure 4
4. Put both wheels on axle, solid sides
together (Figure 5).
Figure 5
5. Attach opposite ring in the same
manner (Figure 6).
Figure 6
6. Slide wheels out and snap axle into
place on the underside of body
(Figure 7).
For parts, product & service information
visit www.campbellhausfeld.com
Electric Pressure
Washer
NOTE: REFER TO PRODUCT MANUAL FOR
ALL SAFETY INSTRUCTIONS
Motor Power
(Single Phase) Voltage
14.5 Amps 120 V
Figure 7
7. Snap wheel covers on the wheel.
8. Attach foot to front of pressure
washer body (Figure 7).
9. Hook up chemical suction hose to the
Solid
tip on the bottom of the handle
Sides
(Figure 8).
Figure 8
10. Attach black handle with enclosed
screws and washers (Figure 9).
Figure 9
Approved
U L
#7P64
PW1676
Maximum Inlet Unit
Water Temperature Weight
100˚F 39 lbs.
IN457000AV 4/00