Troubleshooting - Princess 182065 Manual De Usuario

Instruction manual
• Rinse all other used parts with dish soap and warm water or in the
dishwasher. In the case of stubborn dirt, we recommend soaking the
accessories in warm water and washing-up liquid beforehand.
• The door is detachable for easy cleaning, open the door to a 45° angle
and pull out the door. The door is not dishwasher safe.
• Allow all parts to dry completely or dry them with a towel.
8

TROUBLESHOOTING

Problem Possible cause
The oven does not work. The appliance is not plugged in.
You have not turned on the
appliance by setting the cooking
time and temperature.
The product window is not
closed properly.
The ingredients fried with the aero Too much amount of food.
fryer oven are not done.
Setting temperature too low.
The ingredients are fried When tray is used to make food,
unevenly. the tray position is not adjusted.
White smoke comes out of the You are preparing greasy
appliance. ingredients.
The pan still contains grease
residues from previous use.
Fresh fries are not crispy. The crispiness of the fries
depends on the amount of oil and
water in the fries.
All lights flash and error code E1
appears on the display.
E2
Solution
Plug power cord into wall socket.
Set the temperature and time as
instructed.
Check that window is closed.
Reduce the amount of food for
single cooking.
Set the temperature higher.
During cooking, adjust the tray
position appropriately.
When you fry greasy ingredients
in the aero fryer, a large amount
of oil will leak into the pan. The oil
produces white smoke and the
pan may heat up more than usual.
This does not affect the appliance
or the end result.
White smoke is caused by grease
heating up in the pan. Make sure
you clean the pan properly after
each use.
Make sure you dry the potato
sticks properly before you add the
oil. Cut the potato sticks smaller
for a crispier result. Add slightly
more oil for a crispier result.
Broken circuit of Contact Customer Care Team.
the thermal
sensor.
Contact Customer Care Team.
Short circuit of
the thermal
sensor.