Shimming And Anchoring Lift To Concrete - Autoquip P-25-005 Manual De Instalación, Operación Y Servicio

11. Base frame of lift has pre-drilled holes for anchoring floor. Anchor lift to floor. Lifts with oversize
platforms have minimum pull out requirements of 2,000 lbs. for each anchor. See "Shimming
And Anchoring Lift To Concrete".
12. Route hydraulic hose or electrical cord through conduit in pit wall.
13. Make permanent electrical and hydraulic connections and operate lift through a few cycles.
14. Clean up debris and spilled oil from area. Dispose of oil in an environmentally safe manner.
15. Touch-up paint is available from Autoquip for repair of damaged paint surfaces.
16. Train personnel on lift operation, all safety features and procedures.

4.2 Shimming And Anchoring Lift To Concrete

Recommended concrete anchor bolts are: HILTI "Kwik-Bolt", Molly Parabolt or similar.
1. Verify lift is positioned correctly.
2. Drill holes in concrete as specified by anchor bolt
manufacturer.
3. Install and tighten anchors as specified by anchor
bolt manufacturer.
4. After lift has been aligned, leveled and shimmed,
and anchors have been installed, pour grout under
entire base frame.
5. When grout has set and cured, tighten nuts on
anchor bolts.
18