Autoquip P-25-005 Manual De Instalación, Operación Y Servicio página 28

i DANGER
Do NOT used compressed air to push piston out of cylinder.
1. Remove set screw (A).
2. Unscrew gland (C) using a spanner wrench.
3. Slide rod out of barrel.
4. Remove set screw (B) from end of piston and unscrew piston from rod.
5. Remove seals. Record the position of each seal.
6. Install new seals in reverse order of removal.
6.3.1.6. Install Cylinder
1. Install end of cylinder rod into crosshead mount.
Align holes and insert pin (A).
2. Position cylinder base and install retainer clips (B)
and bolts.
Loctite PST #567 pipe thread sealant or equivalent is
recommended. Do not use Teflon tape. Tape fragments
may cause hydraulic system to malfunction.
i WARNING
Prevent serious injury or death.
HVF is attached to elbow fitting in rod port of cylinder. Do not use a swivel
fitting between HVF and cylinder. If HVF is installed improperly, it will not
lock up in event of a hydraulic line failure.
Arrow (C) on hydraulic velocity fuse indicates direction of oil flow
restriction. Hydraulic velocity fuse must be installed with arrow
pointing away from cylinder.
3. 3. Connect cylinder hose(s).
4. Check that lift anchors are tight (when used). Check all pins
and other mechanical and hydraulic connections.
5. Restore oil level. See "Oil Requirements" and "Oil Capacity"
sections.
6. Turn on electrical power and press "UP" operator control. It may take a few seconds to fill
empty cylinders. Raise lift approximately one inch and disengage maintenance devices.
28