Phase Control; Regulation Devices Fixing; Hook Up To The Power Supplier - Munters Desert cooler DCP30 Manual De Empleo

Desert-cooler: DCP30; DCP30 Top4
The phases are:
- Unfasten the four closing screws from the electrical
panel.
- At this point we are at the situation described in
Attachment 2 where the hook ups that the installer must
effect are highlighted in black.
- Effect the connections
- Close the panel with the four screws keeping the seal in
position.

Phase control

Following the hook up verify that the fan blades are turning
in the indicated way. If this is not the case, modify the hook
up by inverting two phases.
N :
OTE THE PHASE INVERSION OPERATIONS MUST BE EFFECTED WITH
THE MACHINE TURNED OFF

Regulation devices fixing

The regulation devices (thermostat / humidity regulation) must be solidly fixed to the wall.
The electrical hook up must be made with a sheathed PVC cable 3x 1.5 placed in a tube and fixed to the wall.

Hook up to the power supplier

The hook up must be made at the point of delivery with an electrical panel, according to the indications
prescribed by the CEI EN 60204-1 norm.
The electrical supply line must be proportioned to the power absorbed by the fan and by the pump according
to the distance from the point of delivery, keeping in mind eventual decreases of power.
Distance Cable sect. / laying type
200 m PVC 3x1,5 / 34
200 m PVC 2x2,5 / 34
NOTE:
THE INTERRUPTING POWER VALUE OF THE GENERAL SWITCH
ICC
GREATER VALUE AT THE POINT OF
,
SWITCH WITH THE CHARACTERISTICS OF THE SYSTEM
HC/MIT/UgGB-0599-02/06
2006
IS 50 KA. I
DELIVERY,
IT IS NECESSARY TO INSTALL A PROTECTION BACKUP
.
Fig10 Electrical panel
Line protection
6 A
10 A
N THE CASE THAT THE SUPPLY HAS A
15(96)