Atos Unify OpenStage M3 Ex Manual De Utilización página 22

Inserting/replacing the Ex battery pack
1. Remove the sealing cover and, if present, the old
Ex battery pack.
Your phonebook entries and all settings remain
stored even if you remove the Ex battery pack.
The date and time settings will be reset.
2. Insert the Ex battery pack (at an angle, tab first
and the contacts facing down). Then press it
down into the compartment until the Ex battery
pack's positioning clip firmly snaps into place.
Inserting the sealing cover
1. Remove the sealing ring if present.
2. Insert the sealing cover (1) with the labelled side
facing up and press firmly into place on all sides,
making sure it fits correctly. The protrusions on
the side (2) of the sealing cover must fit precisely
into the designated notches on the side.
The protrusions should be visible externally when
the cover is attached and are used for checking
that the sealing is in place and fitted correctly.
2
1
22
2
2
1