Husqvarna ROYAL 153 S Manual De Instrucciones página 11

ENGLAND
P P P P P
Keep the engine stop lever (14) depressed during machine operation. When the lever is
released, the engine stops.
MOWING
To cut the grass, push the lawn mower manually or insert the automatic advance gear.
Before proceeding with the coupling of the automatic feed, choose the speed by means
of the change lever (20).
Q Q Q Q Q
With engine running, pull the handle (14) towards the bar and keep depressed. Push the
blade engagement lever (19) forward to make the blade rotate.
WARNING! When the handle (14) is released the blade stops while the motor continues
running.
R R R R R
With engine running, pull the handle (14) towards the bar and keep depressed. Push the
blade engagement lever (19) forward to make the blade rotate.
WARNING! When the handle (14) is released the blade stops while the motor continues
running.
MOWING
To cut the grass, push the lawn mower manually or insert the automatic advance gear.
Before proceeding with the coupling of the automatic feed, choose the speed by means
of the change lever (20).
(starts at page 51)
S S S S S
Important: If, when you press the clutch lever, the automatic advance gear does not engage, the clutch cable should be adjusted by inserting the spring (P) in one of the
subsequent holes in the plate (R) or in the hole "S" .
AUTOMATIC ADVANCEMENT
T T T T T
Periodically check the automatic advance assembly and make sure to keep it clean. In particular, the pinion (21) and the gear (22) must be kept perfectly clean. To carry
out this check, you must remove the wheel (23) by unscrewing the screw (24).
SA.ETY RULES
Training
a)Persons under 16 years of age and persons who are not
familiar with the user instructions must not use the lawn
mower.
b)The operator is responsible for the safety of other people
in the working area. Keep children and domestic animals
at a safe distance when the lawn mower is in use.
c)This machine is to be used exclusively for cutting natural
grass. Never use the mower for other purposes (e.g., for
flattening out bumps in the ground, such as mole-hills or
ant- hills).
d)Work only when there is sufficient light.
e)Before mowing, remove all foreign objects from the lawn
which may be thrown by the machine. While mowing,
stay alert for any foreign objects which may have been
missed.
Setting up and operating the lawn mower
a)When mowing, wear strong footwear (boots or heavy
shoes) and long trousers.
b)Before you start mowing, make sure that the blade and
blade fixing screw are securely fastened.
If the blade is damaged, it must be replaced.
c)Turn off the engine, wait until the blade has stopped and
remove the spark plug cap before:
l transporting, lifting or moving the machine away from
the working area;
l carrying out maintenance or cleaning, or when carrying
out any operation on the blade;
l adjusting the cutting height;
l leaving the machine unattended.
Caution! The blade starts turning as soon as the engine
is started
d)Caution! The fuel is highly inflammable:
lStore fuel in containers specifically designed for this
purpose.
l Refuel outdoors only and do not smoke while refuelling.
(starts at page 51)
(starts at page 51)
(starts at page 51)
(starts at page 51)
l Fill up the fuel tank before starting the engine. Under no
circumstances open the fuel tank cap or add petrol when
the engine is running or when it is still hot.
l If the petrol has overflowed, do not under any
circumstances start up the engine.Move the mower away
from the area where fuel has bean spilt and avoid any
source of possible ignition until the petrol fumes have
dissipated.
l Replace the fuel tank cap and tighten it down firmly.
e)Do not operate the engine in a confined space where
dangerous carbon monoxide fumes can collect..
f) When mowing, never run; you must always walk.
g)Exercise extreme caution when turning or when pulling
the lawn mower towards you.
h)Particular precautions must be taken when mowing on
slopes or downhill stretches:
lUse appropriate antislip footwear.
l Always be sure of your footing.
l Mow across the face of slopes, never up or down.
l Take great care when changing direction.
lDo not mow on excessively steep slopes.
i)Never use the lawn mower unless the guards and safety
devices (e.g. deflector, grass catcher) are securely in
position and in good condition.
j)Ensure that the grass catcher and deflector are correctly
located. faiture to do so may result in foreign objects being
ejected by the blade.
k)For reasons of safety, the engine must never exceed the
speed. (r.p.m.) indicated on the label.
l) Take care when starting the engine and be sure to follow
the user instructions. Never place your hands or feet
underneath the deck or into the rear discharge chute
while the engine is running.
m) Never lift the rear of the mower while starting the engine
Change the speed with the clutch disengaged. There are 3 speed settings.
1°~ 0,6 m/s
2°~ 0,9 m/s
3°~ 1,2m/s
How to insert automatic advance: Lift up the clutch handle (18) and keep it pressed in
position.
CAUTION: Engage the gear only when the engine is running.
How to disengage advance: Release the clutch handle.
MOWING
To cut the grass, push the lawn mower manually or insert the automatic advance gear.
How to insert automatic advance: Lift up the clutch handle (18) and keep it pressed in
position.
CAUTION: Engage the gear only when the engine is running.
How to disengage advance: Release the clutch handle.
Change the speed with the clutch disengaged. There are 3 speed settings.
1°~ 0,6 m/s
2°~ 0,9 m/s
3°~ 1,2m/s
How to insert automatic advance: Lift up the clutch handle (18) and keep it pressed in
position.
CAUTION: Engage the gear only when the engine is running.
How to disengage advance: Release the clutch handle.
or during normal operation.
n) If the blade happens to hit any obstacle, stop the engine
at once and remove the spark plug cap. Then get an
expert to examine the blade.
Maintenance and storage
a)Make sure that all nuts, bolts, and screws are kept well
tightened to keep the mower in a safe operating condition.
b)Never leave the machine with fuel in the tank within an
enclosed area where the fuel vapours could reach naked
flames or sparks.
c)Allow the engine to cool before storing in any enclosure.
d)Keep the engine, silencer, battery compartment and
petrol tank free from grass, leaves and excess lubricant,
in order to reduce the danger of fire.
e)Frequently check the grass catcher for wear or
deterioration
f)For safety reasons, be sure to replace worn-out or
damaged parts in due time.
g)If the fuel tank has to be drained, it is essential that this
be done outdoor.
h)Assemble the blades following the corresponding
instructions and use only blades bearing the maker's
name or the trademark of the manufacturer or supplier
and marked with the reference number.
i)To protect hands during disassembly or assembly of the
blades, it is absolutely essential to wear suitable
protective gloves.
10