Plantronics CA20 Manual Del Usuario página 8

REGISTRATION OF THE BASE UNIT AND REMOTE PACK
(Fig. 3)
1 Once the remote unit is fully charged, plug in your chosen Plantronics headset to the port (19).
2 Re-dock your remote pack into the base unit.
3 Push down the tone control switch (18), and hold for 5 seconds before releasing. The on-line
LED on the base unit will flash (17).
4 Press the mute button on the remote pack (15) and hold for 5 seconds before releasing. If the
registration of the remote unit to the base unit has been successful, the 'on-line' buttons on the
remote (17) and the base unit (17) will be illuminated, within 60 seconds. The LED illumination
will be intermittent on the remote (17) and permanent on the base unit (17).
If the LED's are not illuminated in this way, repeat the process.
ESTABLISHING COMPATIBILITY
The CA20 Adapter is supplied with it's compatibility switches set to work with 90% of telephones.
If however, you do not get a dial tone when lifting your receiver, please follow these steps:
1 Set compatibility switch 1 to position A and compatibility switch 2 to position 1 (20).
2 Lift your receiver and listen for a dial tone. If there is no tone, repeat the steps below for the
following switch positions:
Switch 1
Switch 2
One of these configurations will give you a dial tone.
If you have followed these steps and still experience problems, please contact your nearest
Plantronics office (for details see reverse of guide).
SETTING THE VOLUME LEVELS
(Fig. 4) In order to set the transmit and receive volume levels, you will need the help
of a colleague.
1 The transmit level controls how loud or quiet your voice is heard by people on the other end
of the line. Put on your headset ensuring that the headset/handset switch (11) is in headset
mode. Make a call to a colleague. Using the transmit volume control (12), adjust the sound
level until your colleague says that the ideal sound level is reached.
2 The receive level (14) allows you to adjust the volume of your callers' voice. To change the
volume, rotate the volume control on the remote unit until the appropriate level is reached.
3 It is also important to ensure that the volume control on your telephone is correctly adjusted to
work in harmony with your CA20 Adapter. Ensure that the volume on the phone is set to mid-range.
USING THE CA20 ADAPTER
Mute Button (Fig. 5)
1 Press the mute button (15) to stop callers hearing you. (You can still hear them). When the
mute button is pressed, you will hear a beep through the headset and the mute indicator
light (16) on the remote pack will illuminate. Press the mute button again to re-establish
the connection.
A B
2 1
B
2
INSTRUCTIONS
6