American Legend FT200 Manual Del Usuario página 6

8 pcs - H1 Phillips Round Head Screw
8 pcs - H6 Allen Head Bolt
8 pcs - H7 Flat Washer
STEP 2:
Attach P2 End Aprons to previous assembly STEP 1 using H6 Allen Head Bolts with H7 Flat Washers as shown in
FIGURE 2. Do not tighten H6 Allen Head Bolts on this time.
Please make sure P3 Playfield is flush with both ends of P2 End Apron, tighten H6 Allen Head Bolts using A3 Allen
Wrench on this time.
Secure P3 Playfield to P2 End Apron using pre-drilled holes with H1 Screws as shown in FIGURE 2.
IMPORTANT NOTE: All screws must be screwed STRAIGHT down. Tighten, but do not strip out H1 Screws.
Using A2 Allen Wrenches to tighten H4 Support Rod Nuts as shown in FIGURE 2.
P2
FIGURE 2
All Rights Reserved.
© 2019 Escalade Sports
PARTS REQUIRED:
2 pcs - P2 End Apron
2 pcs - A2 6mm Allen Wrench
1 pc - A3 4mm Allen Wrench
P3
H4
H7
H6
IMPORTANT NOTE:
Bottom of P1 Side Aprons and P2 End Aprons
must be flush with each other before tightening
H6 Allen Head Bolts.
6
IMPORTANT NOTE:
P3 Playfield must be flush with each
end of P2 End Aprons before
tightening H6 Allen Head Bolts.
H1
A2
For Customer Service Call 1-888-996-2729
P2
H7
H6
A3