Starting + Stopping; Operating Tips - SNOWJOE 24V-X2-20SB-CT Manual Del Operador

Starting + Stopping

TOOL ONLY
BATTERY + CHARGER SOLD SEPARATELY
In order to operate this cordless snow blower you will
need two batteries and one charger from the iON+ 24V
System. See page 17 for battery and charger options and
specifications, or for more information visit snowjoe.com.
1. Open the battery compartment cover and slide each
battery down until it clicks to lock it into position (Fig. 14).
Fig. 14
2. While depressing the safety switch button, pull the
ON/OFF trigger toward you. Once the machine powers on,
release the safety switch button and begin operation
(Fig. 15). The machine can only be started by depressing
the safety switch button first, followed by squeezing
the ON/OFF trigger; reverse operation will not start the
machine.
Fig. 15
Safety switch
button
3. To power off, release your grip on the ON/OFF trigger.

Operating Tips

m
glass, nails, wire, or string, can be picked up and thrown by
the snow blower, causing serious personal injury. Remove all
foreign objects from the area to be plowed before operating
the snow blower.
1. Keep the area of operation free of foreign objects that
Battery
compartment
2. Keep children, pets, and bystanders away from the area of
cover
Battery packs
3. When moving the snow blower, use the wheels on one
4. Start your clearing path outward, throwing snow in a back
5. Note the wind direction. If possible, move in the same
6. Do not push the snow blower with excessive force.
7. Do not apply additional man-made load to the motor since
8. Some parts of the snow blower may freeze under extreme
On/Off trigger
9. When working on pebbles, gravel, or unpaved surfaces,
10. For larger areas, a definite pattern of operation is required
12
WARNING!
Foreign objects, such as rocks, broken
can become thrown by the blades. Perform a thorough
inspection of the area since some objects may be hidden
from view by surrounding snow. If the snow blower hits
an obstruction or picks up a foreign object during use,
stop the snow blower, remove the batteries, remove the
obstruction, and inspect the unit for damage. Repair or
replace any damaged part before restarting and operating
the unit.
operation. Be aware that the normal noise of the machine
when turned on may make it difficult for you to hear
approaching people.
side as the pivot point. Slightly tilt the snow blower on this
pivot point to move it forward or backward.
and forth motion. To clear in the opposite direction, pivot
the snow blower on its wheels. Make sure to overlap
clearing paths.
direction as the wind so that the snow is not thrown
against the wind (and thus back into your face and on the
just cleared path).
You should push the machine gently and evenly in
accordance with the unit's throw rate.
this may cause motor damage.
temperature conditions. Do not attempt to operate the snow
blower with frozen parts. If the parts freeze while the snow blower
is in use, stop the snow blower, remove the batteries, and inspect
for frozen parts. Free all parts before restarting or operating the
snow blower. Never force controls that have frozen.
avoid throwing loose surface material along with the snow
by pushing down on the handle to raise the scraper at the
base of the unit above the pebbles or gravel.
to thoroughly clean an area of snow. These patterns will not
only avoid throwing snow in unwanted places, but will also
eliminate the need for a second removal of snow (Fig. 16).
Pattern A: Throw the snow to the right of left side
where possible. For areas such as a long driveway, it is
advantageous to start in the middle. Plow from one end to
the other, throwing snow to both sides.
Pattern B: If the snow can only be thrown to one side of
the area to be cleared, start on the opposite side.