Stopping The Machine - SNOWJOE iON100V-24SB-CT Manual Del Usuario

IMPORTANT! DO NOT overload unit capacity by attempting to
clear snow at too fast a rate. Use slow speed to clear deep or
hard packed snow.
4. Squeeze drive trigger against the right-handle and the
snow blower will move (Fig. 23). When the blower is
moving steadily, you can release the drive trigger while
keep the auger trigger squeezed to maintain the snow
blower's movement. Release the auger trigger and both
the drive motion and plow motion will stop.
Fig. 23
Drive trigger
(Right-handle)
5. Use the drive speed control lever, adjust the speed for a
comfortable pace (Fig. 24).
Fig. 24
IMPORTANT! Drive speed can be changed without stopping
the snow blower.
Fig. 22

Stopping the Machine

Auger speed
control lever
Reverse Traveling
Be careful when moving backward with the snow blower.
Always look down and behind before backing up. For safety
reasons, the machine cannot throw snow when moving
backward. When auger trigger is activated during reverse
travelling, the machine will exit the reverse mode and stop.
Drive speed
control lever
16
1. Release the auger trigger. Drive motor and auger will both
stop (Fig. 25).
2. Wait for all moving parts to come to a complete stop.
3. Remove the batteries.
Fig. 25
1. Before backing up, stop the machine by release both
triggers and wait until all movement come to a complete
stop.
2. Press the reverse button, the reverse indicator LED will
light up to indicate that the machine is in reverse mode
(Fig. 26).
3. Squeeze drive trigger against the right-handle and the
snow blower will move backward (Fig. 26).
Fig. 26
Press the reverse button
2 Squeeze the drive trigger
Auger trigger
(Left-handle)
1