Using The Fryer; Gas Fryers - horeca F64G8 Instrucciones Para Instalación, Uso Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 51
use. Any other use is considered to be im-
proper.
• Do not allow the appliance to operate emp-
ty for prolonged periods. Only pre-heat the
oven just before use.
• Do not leave the appliance unattended
while in operation.
• In the event of an appliance fault or mal-
function, shut the gas shut-off valve and/or
switch the appliance off at the main switch
installed upline.
• Clean the appliance following the instruc-
tions given in Chapter " INSTRUCTIONS
FOR CLEANING".
• Do not store flammable materials in close
proximity to the appliance. FIRE HAZARD.
• Do not obstruct any air vents or drains pre-
sent on the appliance.
• Do not tamper with appliance components.
• Do not use flammable products to clean
the appliance.
• Take care when handling accessories (e.g.
pans) and movable parts of the appliance
to use the correct posture.
• Appliances of this type are intended for
use in commercial applications such as,
for example, the kitchens of restaurants,
canteens, hospitals and businesses such
as bakers, butchers etc., but they are not
intended for the continuous mass produc-
tion of food.
• The use of personal safety equipment is
recommended - risk of very hot food being
scattered.
• During appliance operation, the floor sur-
rounding the appliance may become slip-
pery: exercise caution and take all suitable
measures to prevent falls.

USING THE FRYER

REMINDERS FOR USE
• The appliance is designed for frying food in oil or solid fat.
• Do not place large pieces of food or food that is dripping with
water in the well because this action may produce splashes
of boiling oil and cause the oil to overflow.
• Top up the oil level whenever it falls below the minimum refe-
rence mark (fire hazard). Before pouring in oil make sure that
there is no water in the well.
• Pour oil into the well up to the level indicated by the reference
mark on the well rear/side wall.
• When using solid fat, melt the fat separately before pouring it
into the well. Do not leave the fat in the well when you have
finished cooking.
• Gradually immerse the basket containing the food to be fried
into the boiling oil and take care that the resulting foam does
not spill over the sides of the well. If this should occur, stop
immersing the basket and wait for a few seconds.
• Do not activate the heating system when there is no oil or fat
in the well.
• While the fryer is on, the oil level must be maintained in cor-
respondence with or above the minimum level mark indicated
on the rear wall of the well.
• The appliance is equipped with a manual reset safety ther-
mostat which interrupts heating when the operating tempera-
ture exceeds the maximum permitted value.
• You have to pay particular attention to the fact that the old
fat and oil and the dirt, have a reduced ignition temperature
and will increase its tendency to boil suddenly and the foam,
which results, may overflow.
FILLING AND EMPTYING THE WELL
Filling
• Turn handle of the drain valve.
• Fill the well until the water is level with or above the minimum
level ( bottom mark ) indicated on the rear wall of the well.
Emptying
• Switch the heating off.
• Wait for the oil to cool
• Connect the extension (if present) to the drain valve.
• Place a suitable receptacle to hold the drained oil under the
drain extension.
• Turn the drain valve handle slowly. Use caution when carrying
out this procedure. DANGER of scalding from hot oil.

GAS FRYERS

The gas valve control knob has the following positions
Off
Pilot ignition
1...6 Intermediate cooking temperatures
7 Maximum cooking temperature
BURNER IGNITION AND EXTINCTION
Pilot ignition
Press and turn the knob to position "
• Press the knob down fully and light the pilot using the piezo-
electric igniter.
• Hold the knob down for about 20 seconds before releasing it.
If the pilot flame goes out, repeat the operation.
• The pilot flame can be seen by opening the door
• The pilot light can be lit by bringing an open flame up to the
nozzle.
Main burner ignition
• Turn the knob to the chosen temperature setting for cooking.
Switching off
To switch the main burner off, turn the knob to position "
To switch off the pilot flame, press and turn the knob to position
"
".
".
".
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

F66g8Efg62108tEfg63208tOf64g8Of66g86nfr/g400 ... Mostrar todo

Tabla de contenido