Troubleshooting - Tru-Test WaterPro 2 Guia Del Usuario

Troubleshooting

Symptom
Water frozen in tank Water frozen in lines or
connections.
Low water flow Blockage or kinks in valves or
vertical water supply line.
Shut-off valve not set correctly.
Water dripping out of Seals may need replacing.
valve
Valve does not shut Worn diaphragm.
off
Drain plugs leak Worn drain plug or drain plug
screw not tightened.
Possible cause/s Solution/s to check or action:
Vertical water supply line is properly insulated.
Tank bottom is sealed on concrete.
Livestock are drinking from the WaterPro2, if not, drain and refill
to recycle fresh water.
Vertical water supply line is centered within the thermal earth
tube.
Horizontal water supply line is 1 foot (51 mm) below the frost
line.
Vertical water supply line is free from kinks.
Valve and float assembly has no blockages.
Shut-off valve is set to the open position. See the images of shut-
Step 8: Checking for leaks
off valve positions in
Check water pressure with a pressure gauge.
Check the valve diaphragm and seals.
Check that the valve connections have been tightened.
Valve and float assembly is clear of debris.
The shut-off valve is set to the open position. See the images of
shut-off valve positions in
Replace valve and float assembly diaphragm.
Check pressure and flow capacity. See
on page 11.
Replace drain plug.
Tighten drain plug.
on page 10.
Step 8: Checking for leaks
Pressure and flow capacity
on page 10.
13