Install Your Calypso - STA-RITE Calypso GW7000 Manual De Instalación, Operación Y Repuestos

INSTALL YOUR CALYPSO

Step 1: Install Vacuum Port Door fitting
If there is no spring-loaded door on the vacuum port, in-
stall the included cover.
If your pool only has a skimmer, and no dedicated vac-
uum port, proceed to Step 3.
Figure 3 - Vacuum Port Installation.
1. Screw the fitting into the port opening.
2. Orient the fitting so the arrow on the door point up.
3. Secure the cover by tightening the allen-screw below
the door.
Step 2: Install Regulator in Pools with a
Dedicated Vacuum Port
The pool regulator adjusts the amount of vacuum in the
line for optimum cleaning.
If your pool has a dedicated wall fitting in addition to the
skimmer, follow the procedure below.
1. Turn off the pool pump.
2. Place the regulator in the skimmer as shown. The cap
must be placed in the top
Use the adapter cone if needed.
Skimmer
Figure 4 - Regulator in Skimmer.
Cap
Regulator
Adapter Cone
To Pump
3. Attach one length of hose to the vacuum port
Hose
End
Figure 5 - Vacuum Port Connection.
Step 3: Pools with only a Skimmer
1. Turn off the pool pump.
2. Place the regulator in the skimmer as shown. Do not
install the cap.
Use the adapter cone if needed.
Skimmer
Figure 6 - Regulator in Skimmer.
3. Submerge one length of hose so it becomes filled
with water.
4. Insert the "male" end of the hose into the regulator.
4
Vac Port
Fitting
Regulator
Adapter Cone
To Pump