Westin 23-2340 Manual De Instrucciones

AUTOMOTIVE PRODUCTS, INC.
STEP BAR ASSEMBLIES
ENSAMBLES DE ESTRIBOS
MONTAGES DE MARCHE-PIEDS
23-2340
23-2345
QTY
ITEM
1,2 2 STEP BAR, PASSENGER (1) AND DRIVER (2)
3,4 2 DRIVER SIDE BRACKET, FRONT(3) AND REAR (4)
5,6 2 PASSENGER SIDE BRACKET, FRONT(5) AND REAR (6)
7 16 M8-1.25 X 30MM HEX HEAD BOLT
8 24 M8 FLAT WASHER
9 16 M8 LOCK WASHER
10 8 M8-1.25 HEX NUT
11 8 M8-1.25 X 30MM BUTTON HEAD BOLT
12 8 M8 INTERNAL TOOTH FLAT WASHER
13 8 M8-1.25 NUT-CLIP
1,2 2 ESTRIBOS, LADO DEL ACOMPAÑANTE
3,4 2 SOPORTE DE LADO DEL CONDUCTOR, DELANTERA (3) Y TRASERAS (4)
5,6 2 SOPORTE DE LADO DEL ACOMPAÑANTE, DELANTERA (5) Y TRASERAS (6)
7 16 PERNOS CON CABEZA HEXAGONAL DE M8-1.25 X 30MM
8 24 ARANDELAS PLANAS DE M8
9 16 ARANDELAS DE PRESIÓN DE M8
10 8 TUERCAS HEXAGONALES DE M8-1.25
11 8 PERNOS TERMINALES DE M8-1.25 X 30MM
12 8 ARANDELAS DE PRESION DE DENTADO INTERIOR DE M8
13 8 ABRAZADERAS DE M8-1.25
1,2 2 MARCHE-PIEDS,
3,4 2 SUPPORT
5,6 2 SUPPORT
7 16 BOULON A TETE HEXAGONALE DE M8-1.25 X 30MM
8 24 RONDELLE PLATE M8
9 16 RONDELLE A FREIN DE M8
10 8 ÉCROUS HEXAGONAUX M8-1.25
11 8 BOULON A TETE RONDE DE M8-1.25 X 30MM
12 8 RONDELLE A FREIN A DENTS INTERIEURES DE M8
13 8 ECROUS "U" EXTRUDES DE M8-1.25
STEP 1. Remove contents from box and check for damage. Verify all parts are present. Read instructions completely before
beginning.
STEP 2 Remove black tape over mounting holes located on the inside face of rocker panel.
.
STEP 3 . Install extruded "u" nuts into mounting holes.
STEP 4.
Attach front and rear brackets (Rear Brackets are longer). Hand tighten.
STEP 5. Attach step bar as shown.
STEP 6. Make sure step bar and brackets are properly aligned and tighten all fasteners. Recommended torque values are 23
Ft.Lbs for M8 fastemers.
FINISH PROTECTION
Westin products have a high quality finish that must be cared for like any other exposed finish on the vehicle. Protect the finish with a non-abrasive automotive
wax, (e.g. Pure Carnauba) on a regular basis. The use of any soap, polish or wax that contains an abrasive is detrimental, as the compounds scratch the finish
and open it to corrosion.
INSTRUCTIONS-INSTRUCCIONES-CONSIGNES
APPLICATION: 2004-08 FORD F-150 REGULAR CAB(NOT HERITAGE EDITION)
APL ICACIÓN: FORD F-150
APPLICATION: 2004-08 FORD F-150 CABINE REGULIERE (NOT HERITAGE EDITION)
1
CONTENTS - CONTENIDO - CONTENU
CÔTÉ PASSAGER (1) ET CÔTÉ CONDUCTEUR (2)
CÔTÉ CONDUCTEUR, AVANT(3) ET ARRIERE (4)
CÔTÉ PASSAGER, AVANT (5) ET ARRIERE (6)
SEE FIGURES 2 AND 3.
NOTE: Westin advises the installer to use a thread lubricant on the stainless steel applications.
CABINA REGULAR MOD. 2004-08
2
(1) Y EL CONDUCTOR (2)
SEE FIGURE 1.
Page 1 of 3
(NO PARA LA EDICION DE HERITAGE)
4
3
TOOLS - HERRAMIENTAS
13MM SOCKET
13MM WRENCH
RATCHET
12MM WRENCH
TORQUE WRENCH
DADO DE 13MM
LLAVE DE TUERCAS DE 13MM
MANERAL
LLAVE DE TUERCAS DE 12MM
LLAVE DE TORQUE
DOUILLE 13MM
CLE 13MM
CLE
CLE 12MM
CLE DE COUPLE
SEE FIGURE 2.
REVISION A 3/24/08
6
5
- OUTILS