• Do not use this tool to fasten electric cables. This tool is not
designed for the installation of electric cabling and may damage
electric cables which could lead to injury by electric shock or
fire hazards.
• Use appropriate detectors to determine if any utility lines are
hidden within the work area or call your local utility company
for assistance. Should electric lines be damaged this could
lead to fire and electric shock. Damaged gas lines could lead to
explosions. Penetrating a water line can cause property damage.
• When using the power tool hold it in such a manner that your
head and/or body cannot be injured by the tool suddenly
kicking back due to a malfunction of the battery or from
objects in the work area.
• Do not attempt to open the battery pack. There is a danger of
short-circuiting.
• Protect the battery against heat (continuous intense sunlight),
fire, water and moisture. There is a danger of explosion.
• A damaged battery or one that is subject to improper use can
emit vapours. Ventilate the area and seek medical help if needed.
The vapours can irritate the respiratory system.
• Only use the battery in conjunction with your Tacwise power
tool. This will protect it against overloading.
• Use only original Tacwise batteries with the voltage listed
on the nameplate of the power tool. There may be a danger of
Cd
injury as well as property damage through exploding batteries that
are imitations, reconditioned or other brands.
• The electric motor has been designed for one voltage only.
Always check that the battery pack voltage corresponds to the
voltage on the rating plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Cd
Model and Serial No.
The model name of this tool will be found on a label located on the
tool's magazine channel and the serial number is located on the body
of the tool that houses the battery. Please record the model name and
serial number in the space provided below. Please always give the
following information when contacting us:
Cd
MODEL NAME .............................................................
SERIAL NUMBER .........................................................
Cd
Explanation of Label on Power Tool
Always observe the safety instructions and warnings
Explanation of Label on Battery Pack
Read instruction manual before use
Do not charge damaged battery packs
Do not incinerate the battery pack
8
+45°C
Li-ion
Explanation of Label on Battery Charger
Cd
Cd
T2A
Service
Any servicing requires specialist tools and knowledge and should be
performed only by a qualified Tacwise Service Engineer or appointed
Service Agent. We strongly recommend that the main housing of
the tool is not opened, as such action may result in injury and may
compromise the tool warranty.
Usage Advisories
1. Operate the tool in cycles of 15 minutes to avoid the tool and
battery from over-heating.
2. It is suggested that you do not exceed firing 200 fasteners in any
one continual use.
3. Leave the battery to cool down before charging to achieve
optimum performance.
Charge at temperatures between 5°C and 45°C only
0°C
Recyclable
Dispose of batteries in accordance with
environmental legislation
CE: Conforms with EC directives
Read instruction manual before use
Use indoors only
Electrical safety; make sure the voltage of your
charger corresponds to that of your mains
Danger - electrical item
Dispose of electrical equipment in accordance with
environmental legislation
Takes T2A fuse
CE: Conforms with EC directives
GS: Conforms with German Product Safety Act