Forch INOX CLEANER 350 W Manual De Instrucciones página 18

Weldseam Cleaner INOX CLEANER 350 W
ENG
Note
Please read these instructions carefully before taking the unit into operation. It contains
numerous references to the intended use of the device.
Please keep the instruction at hands for future reference.
Hazards
The INOX CLEANER 350 W may not be in a damp place, and may not be exposed to
precipitation, splash water, dust or constant direct sunlight.
Avoid strong mechanical stresses and do not place the INOX CLEANER 350 W on an
unstable base. By the unit dropping people could be injured.
It is only allowed to operate the INOX CLEANER 350 W on AC power network.
The respective tools achieve current levels of 10 to 60 amperes. A touch of the metal parts
can cause burns in humans and animals!
Never leave the switched-on INOX CLEANER 350 W unattended! Never operate the device
near fl ammable or combustible materials or gases.
During the electro-polishing health-impairing vapours are produced. Ensure good ven-
tilation or adequate fume hood. Protect your eyes and body with adequate PPE against
splashes of electrolyte.
Place the handle if work is interrupted only on a non-conductive surface.
The INOX CLEANER 350 W is intended exclusively for electro-polishing, cleaning and sign-
ing of stainless steel. Do not use for heating liquids or plastics.
Only open the INOX CLEANER 350 W for the language setting. The INOX CLEANER does
not have any user serviceable parts. Opening incurs the risk of electric shock.
The device must not be altered, modifi ed or opened, otherwise the warranty is
void. In case of failure, please send the unit to our service.
If the power cable of the INOX CLEANER 350 W is damaged it must be replaced by the
manufacturer, its service agent or a similarly qualifi ed person in order to avoid any hazard.
Clean the INOX CLEANER 350 W only with a dry linen cloth, that might be slightly wet in
case of heavy soiling. Do not use solvent based cleaning agents.
Make sure that no moisture gets to inside of the unit.
A defective INOX CLEANER 350 W must be immediately disconnected from the power
supply and be secured against accidental further use.
Operation