Forch INOX CLEANER 350 W Manual De Instrucciones página 20

Equipo de limpieza de cordones de soldadura
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 54
Starting of the INOX CLEANER 350 W
After having switched on the unit the following information appears on the display
The INOX CLEANER is now ready for operation
Weldseam cleaning with carbon brush
By pressing the button for process selection once the display shows
Attach the grounding terminal to your stainless steel part.
A carbon brush is screwed onto the handle and this one is then connected to the handle
cable.
Plunge the carbon brush into the electrolyte SPEED (in case of overhead work, please
use the electrolyte OVERHEAD).
This electrolyte is pasty and sticks to your part.
Run the carbon brush over the oxide layer to be removed (visible oxide fi lm) until it is
brushed off.
If necessary, plunge the carbon brush repeatedly into the electrolyte.
You therefore do not have to take the brush of the handle cable.
Polish with carbon brush
By pressing the button for process selection twice the display shows
Attach the grounding terminal to your stainless steel part.
A carbon brush is screwed onto the handle and this one is then connected to the handle
cable.
Plunge the carbon brush into the electrolyte for polishing.
Run the carbon brush over the stainless steel and start the polishing process.
This can take several seconds. Finish your work when the desired result is achieved.
Polishing in corners that are diffi cult to reach is possible.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

5462 100

Tabla de contenido