Connecting The Transmitter To Existing Bell Systems Or An Existing Doorbell Button; Connecting The Transmitter To An Existing Bell System - lidl HG00783A-TX Manual De Instrucciones

Extension of an existing doorbell system:
An already existing doorbell system can be extended with this product.
The operating voltage of the doorbell system must be between 4–12 V.
It makes no difference whether this comes from direct current or 50 -
60 Hz alternating current. In the event that you are dealing with an
existing doorbell system using direct current, you must connect the
positive terminal of the doorbell to contact C of the transmitter and
the negative terminal to contact A of the transmitter.
320257_silv_Design-Funktuerklingel_content_US.indd 19
Connecting the transmitter to existing bell
systems or an existing doorbell button
Remove the holder
the transmitter and remove the rubber cover
Open the inner cover
Remove the plastic clip of cable exit hole
screw driver (see fig. G).
Insert the cable through cable holder
(see fig. H).
Connect cable to terminals A and C (for connecting to existing
doorbell) or terminals B and C (for connecting to existing doorbell
button) using screw driver (see fig. H).
Connecting the transmitter to an existing
bell system (see Fig. I)
by pressing the lock
12
using a Phillips screwdriver (see fig. F).
14
20
from the back of
11
(see fig. C1).
16
with a flat head
19
and cable exit hole
US-EN
19
19
01.03.19 12:13