How To Switch On; Channel Selection; Noise Suppression - Sennheiser SKM 5000 Instrucciones Para El Uso

How to switch on the SKM 5000
The handheld transmitter SKM 5000 is
switched on with the switch on the handle. The
green LED next to it indicates that the hand-
held transmitter is ready for operation.

Channel selection

After having removed the power supply unit
(see next page) the channel selector switch is
accessible. Select one of the 16 channels with a
small screw driver (breadth: 2mm) as
adjustment tool. The exact channel for the
transmitter frequencies is given on the sticker
in the microphone handle below the channel
selector switch.
Note
The transmitter frequency must correspond
to the received frequency selected at the
receiver!
The antenna is positioned at the end of the
handheld transmitter SKM 5000 within the
handle.
For not reducing the power do not touch
the handle end during operation!
Transmitter battery status indication only
on 3000 and 5000 series receivers.

Noise suppression

The handheld transmitter SKM 5000 is equiped
with the Sennheiser noise suppression system
HiDyn
plus
be equiped with
SKM 5000, BDA 06/02
™ . Suitable receivers, too, must therefore
™ .
HiDyn
plus
13
13
04.06.2002, 11:18 Uhr