Mounting/Assembly - SPORTSTECH HTX500 Manual De Instrucciones

Firmly tighten all component parts and pre-assembled parts!
Step 1:
Take a stand (#A1) and attach it to either
side with one on each stand extension (#A2)
together.
Repeat this step a total of three times.
Did you know?: Scan the QR code on page
20 and look up our installation video on
YouTube.
Step 2:
Turn one screw (M6 * 10) on both sides
of the stand (#A1) using a curved washer
clockwise into the opening provided and
tighten this.
Repeat this step a total of three times. Put the
three extended feet aside for now.
Step 3:
Now lay out the 6 frame pieces (#A3) in front
of you. Make sure that the brackets of the
feet (#A1) point downwards and the narrow
ends of the frame pieces meet the wide ones
(Fig.3). Put the laid out frame pieces (#A3)
together, by inserting these narrow ends into
the wide ones and then with 6 screws (M6 *
10). Using curved washers in the openings
provided fix in a clockwise direction (Fig.4).
Note: If the last piece turns out to be stiff,
please ask the second person with you to
lightly push the frame in on the diagonally
opposite side and you push from your
direction as you join the Frame Pieces (#A3)
together.

MOUNTING/ASSEMBLY

Figure 1
Figure 2
Figure 3
Figure 4
26