Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Sleep Mode
For extending the battery life of the keypad, the keypad is designed with a Sleep mode
function. By default, 10 seconds after the last key has been pressed, the keypad will
turn off its display and LEDs.
Replacing Batteries
1.
Remove the fastening screw that secures the mounting bracket to the keypad
(see Figure 1).
2.
Slide the keypad and remove it from the mounting bracket.
3.
Remove the battery compartment cover.
4.
Disconnect the battery cable from the battery connector.
5.
Replace the batteries while paying attention to the polarity of the batteries (see
Figure 9).
6.
Reconnect the battery cable to the battery connector.
7.
Close the battery compartment cover, place the keypad back on the wall and
secure the screw to its place.
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to local regulations.
12/2019
Figure 9
Page 11
5IN2812 C
Publicidad
Tabla de contenido
