Required Tools - Merrithew Health & Fitness SPX Reformer Manual Del Propietário

Required Tools

ONE PHILLIPS SCREWDRIVER
TWO OPEN-END WRENCHES
1/2" X 7/16" (13mm X 11mm)
. Insert spring bolt through the corresponding hole on spring
3
anchoring bar.
. Hold fixed cube nut in place with 7/16" wrench.
5
Using second wrench, tighten the new nylon locknut.
Do not reuse old nylon locknuts.
NOTE:
7 . Repeat steps 1 to 6 for remaining springs.
. Thread nylon locknut into spring bolt.
4
. Both nylon locknut and fixed cube nut should be snug against
6
the spring anchoring bar.
8 . Affix the sticker provided with your spring replacement
package to the underside of the Reformer carriage.
Springs should be replaced every 24 months, or as needed
within that period.
15