Uline H-161 Manual Del Usuario página 2

NOTE: The cutter may have a wax coating
that needs to be removed before first use. Use
caution when removing.
1. Plug the power cord into the outlet and set the timer
knob to the thickness of the materials to be sealed.
(See Recommended Settings Table)
2. Put poly bag on the sealing platform and push down
the sealing arm. The sealer will automatically control
the seal time.
CONNECTION DIAGRAM
Heating Element
Transformer
N
Source
L
Microswitch
Connector
SEALER SPECIFICATIONS
MODEL SOURCE
H-161 120 V
H-163 120 V
H-190 120 V
H-293 120 V
H-306 120 V
H-458 120 V
H-963 120 V
H-1029 120 V
H-1252 120 V
PAGE 2 OF 12
OPERATING INSTRUCTIONS
SPECIFICATIONS
Relay DC24V
Sealing Light
D R
Timer
Control P.C.B
IMPULSE MAX. SEAL
POWER LENGTH
410 W
410 W
580 W
580 W
670 W
160 W
670 W
870 W
870 W
3. After one to two seconds, slide the cutter to trim
the bag (only on H-161, H-293, H-963 and H-1252).
Release the sealing arm.
NOTE: The higher the number on the dial, the
longer the heat sealing time.
NOTE: Sealing is complete when the light
turns off.
RECOMMENDED SETTINGS
MODEL 1 MIL
H-161 3
H-163 3
H-190 3
H-293 3
H-306 3
H-458 3
H-963 3
H-1029 3
H-1252 3
MAX. SEAL
THICKNESS
8" 8 Mil
8" 8 Mil
12" 8 Mil
12" 8 Mil
16" 8 Mil
4" 8 Mil
16" 8 Mil
20" 8 Mil
20" 8 Mil
2 MIL 3 MIL 4 MIL
3 3 4
3 3 4
3 3.5 4
3 3.5 4
3 3.5 4
3 3 4
3 3.5 4
3 3.5 4
3 3.5 4
WEIGHT DIMENSIONS
7.7 lbs. 3.2 x 15 x 6.3"
5.8 lbs. 3.2 x 12.6 x 5.9"
8.5 lbs. 3.3 x 17.8 x 7.4"
10.1 lbs. 3.2 x 17.9 x 7.4"
9.9 lbs.
3.7 lbs. 2.8 x 8.3 x 5.9"
11.9 lbs. 3.2 x 21.8 x 7.3"
13 lbs. 4.5 x 28 x 7.8"
13 lbs. 3.2 x 25.9 x 7.4"
6 MIL 8 MIL
5 5
5 5
5.5 5.5
5.5 5.5
5.5 5.5
5 5
5 5
5.5 5.5
5 5
3 x 21 x 7"
0521 IH-161