cecotec BAMBA SCKINCARE Manual De Instrucciones página 24

ENGLISH
Skin type/skin tone
Skin type Skin tone
I White
II Beige
III Light brown
IV Mid-brown
V Dark brown
VII Brownish black or darker
Note: Your skin may react differently on different days/occasions for a number of reasons.
Manual operation method
Plug the device into a power supply. Wait until the ready light indicator turns on red.
Press the On/off/intensity button. The light of intensity level 1 will turn on and the fan inside
the appliance starts.
After about 1 second, the Ready/skin colour warning light comes on. This shows that the
appliance is ready to release a flash.
Press the On/off/intensity button one or more times to choose the intensity level suitable for
the treatment area and your skin colour.
Make sure that the treatment area is clean, dry and properly shaved. Place the skin contact
surface on the skin at a 90º angle.
Press the flash button.
Automatic skin tone detection
Plug the device into a power supply. Wait until the ready light indicator turns on red.
Press the On/off/intensity button. The light of intensity level 1 will turn on and the fan inside
the appliance starts.
Place the skin contact surface on the skin at a 90º angle. The integrated safety system will
prevent unintentional flashing without skin contact. The light indicator will turn on green.
Press the flash button. The device will select an appropriate intensity level for the user
according to the skin tone. The corresponding intensity light indicator will turn on.
46 SKINCARE IPL QUARTZ
Intensity level
4-5
3-4
2-3
1-2
Do not use the device
Do not use the device
Note: It is very important to keep the flash light window tightly closed to the skin in order
for the sensor to be able to detect the skin tone. Since different parts of the skin can have
different tones, repeat the last step every time you change zone.
While the fan is running, hold the flash light window tightly close to the skin and press the
flash button. The light indicator will turn green and blink.
Press the flash button to start removing hair.
Release flashes one next to another to ensure that hair is removed from the whole area.
Make sure not to release more than 1 flash on the same area.
Note:
Do not use any pencil or pen to mark the areas, as this may cause side effects to your skin.
Flashing the same area does not improve the effectiveness of the use but increase the risk of
skin reactions.
When you have finished using the device, hold down the On/off button for 2 seconds to
switch it off.
Flashing methods
Manual flash
Ideal to use on small or curvy areas like knees and underarms. Simply press and release the
flash button to release a single flash.
Sliding flash
Ideal to use on large areas like legs. Keep the flash button pressed while you slide the device
over your skin to release several flasher in a row.
Note: If the cooling fan stops rotating, stop using the device immediately, otherwise it may
lead to flash rupture due to high temperature and damage the skin.
After hair removal treatment
When you have completed your hair removal cycle, press and hold the intensity button to
turn off the device.
Be sure to remember the last intensity level setting used, as the device is automatically reset
to the lowest setting when turned off, and it does not remember the previously selected
setting.
Unplug the device from the power supply.
Skin care after hair removal session
Do not expose the treated skin to the sun. If it is going to be exposed, thoroughly apply SPF 30
or higher sunscreen for 2 weeks after each hair removal.
ENGLISH
SKINCARE IPL QUARTZ 47