TEMPUR-PEDIC Ergo Smart Base Manual De Instalación página 7

CONNECT THE POWER SUPPLIES
12
• Two people are required.
PLACE THE SLEEPTRACKER SENSORS
STEP 13
Install the connector strips at both the
head and foot ends of the base.
• Slightly loosen the adjacent legs
on both bases to allow the strip to
fit between the leg and the frame.
Slide the connecting strip onto the
leg bolts, then secure the strip by
shifting it to the left. Re-tighten legs,
but do not overtighten. The bases
should be touching.
STEP 14
Install mattress retainer bars: slide the left
side of the bar into the bracket, then pull
the retainer bar over the opposite bracket
and insert the right side of the bar into the
opening.
STEP 15
Plug both power supplies into a surge
protector (not included) connected to a
power source. The LEDs under the bed
will blink.
13