Operation - Glacier bay HD67568-1101 Guía De Instalación Y Cuidado

Installation (continued)
3
Tightening the faucet assembly
□
Secure the faucet (A) to the sink using the
mounting nuts (C) provided. Hand tighten only.
C

Operation

1
Flushing and checking for leaks
IMPORTANT: After installation is complete, remove the
aerator from the faucet (A) to ush the water lines. Do not
lose the gasket (1) in the aerator.
□
Ensure the faucet (A) handles are in the off
position and turn on the water supply to check
for leaks. If you discover any leaks, check your
connections to ensure they are installed properly.
□
Remove the aerator and housing (if applicable).
Turn on the hot and cold handles to allow the
water to run for at least one minute. This
ushes away any debris that could cause
damage to internal parts.
□
Turn off the water and reinstall the aerator and
housing (if applicable).
A
4
Making the water supply
connections
□
Use 1/2 in. I.P.S. faucet connections (2), or use
supply line coupling nuts (3) (not included) with
a 3/8 in. O.D. ball-nose riser (1).
□
Use wrenches to tighten the connections. Do not
overtighten.
1
5
Please contact 1-855-HD-GLACIER for further assistance.
1
3
2
A
HOMEDEPOT.COM