Troubleshooting - HAMPTON BAY SL12-6 Manual De Uso Y Cuidado

Installation (continued)
RE-LAMPING STRING LIGHTS
WARNING: RISK OF ELECTRIC SHOCK!
Disconnect power at the source prior to re-lamping the string lights.
For outdoor string lights, DO NOT re-lamp light strings during rain or
when wet.
□ Re-lamp string lights only during dry and calm weather conditions.
□ Unscrew existing lamps by lightly holding the socket in one hand and twisting the lamp counterclockwise. Lamps
may be tight in the sockets. This is normal to prevent moisture from getting into the socket.
□ Replace with medium base lamps. Screw bulbs into the sockets clockwise until the top of sockets form a tight seal
around the bulbs and the bulbs make contact with the sockets. Do not exceed 432 watts all sets combined. Suitable
for Incandescent, CFL or LED lamps.
MAINTENANCE
Periodically clean the string light, check connections and ensure no additional weight has been added.

TROUBLESHOOTING

PROBLEM
The lights will not turn on
The fuse blows, or the
circuit breaker trips, when
the light is turned on.
POSSIBLE CAUSES
The bulb is burned out.
The power is off.
There is a faulty switch.
There is a faulty wire connection.
The bulb is not making contact with
the terminal.
5A fuse in plug has blown.
There are crossed wires, or the
power wire is grounding out.
The receptacle circuit is overloaded.
SOLUTION
Replace the light bulb.
Ensure the power supply is turned on.
Test or replace the switch.
Check the wiring.
Check the position of terminal inside socket.
Remove and replace 5A fuse with new fuse
(sold separately).
Discontinue use of the light string.
Contact a qualified electrician or call the
Customer Care Services Teams.
Connect to a different receptacle circuit.
5