Blower Safety Warnings - Ryobi RBV2800CSV Manual Del Usuario

■ Never use the product with defective guards
or shields, or without safety devices, such
as debris collector, in place.
■ Do not modify the product in any way or
use parts and accessories that are not
recommended by the manufacturer.
■ If the product is dropped, suffers heavy
impact, or begins to vibrate abnormally,
immediately stop the product and inspect
for damage or identify the cause of the
vibration. Any damage should be properly
repaired or replaced by an authorised
service centre.
■ To reduce the risk of injury associated with
contacting moving parts, always turn off the
product and remove the battery pack. Make
sure that all moving parts have come to a
complete stop:
● before leaving the product unattended
● before clearing blockages or unclogging
chute
● before checking, cleaning, or working on
the product
● before inspecting the product after
striking a foreign object
● whenever the product starts to vibrate
abnormally (inspect immediately)
■ Immediately turn off the product and remove
the battery pack in the event of accident
or breakdown. Do not operate the product
again until it has been fully checked by an
authorised service centre.
■ Injuries may be caused or aggravated by
prolonged use of a tool. When using any
tool for prolonged periods, ensure to take
regular breaks.

BLOWER SAFETY WARNINGS

■ Wear a face filter mask in dusty conditions
to reduce the risk of injury associated with
the inhalation of dust.
■ Slightly dampen surfaces in dusty conditions.
■ Do not use the product near open windows.
■ Use the full blower nozzle extension so that
the air stream can work close to the ground
and perform effectively.
■ Use rakes and brooms to loosen debris
before blowing.
■ Do not point the blower nozzle in the
direction of people or pets.
■ Never place objects inside the blower tubes.
■ Do not place product on top of or near loose
debris. Debris can be sucked into the intake
vent, resulting in possible damage to the
product.
VACUUM SAFETY WARNINGS
■ Before using the product in vacuum
mode, the upper and lower tubes must be
assembled. The assembly is a one-time
operation only. Never operate the vacuum
with only the upper vacuum tube fitted.
Failure to follow this warning increases the
risk of personal injury. Without the lower
vacuum tube fi tted, it is much easier to
reach up inside the tube towards the fan
blade.
■ Do not operate the vacuum without the
debris collector bag assembly installed.
Flying debris could cause serious injury.
Make sure that the debris collector bag is
in good condition and completely closed
before operating the product.
■ Move the vacuum from side to side along the
outer edge of the debris. To avoid clogging,
do not place the vacuum tube directly into
the debris pile.
■ Hold the motor higher than the inlet end of
the vacuum tube.
■ To avoid serious injury to the operator or
damage to the product, do not try to vacuum
up rocks, broken glass, bottles, or similar
objects.
■ Avoid situations that could cause fire in the
debris collector bag. Do not operate the
product near an open flame. Do not vacuum
up warm ash from fireplaces and barbecue
pits. Do not vacuum up discarded cigars or
cigarettes unless the cinders are completely
cool.
■ Keep all parts of your body away from any
moving part. Rotating fan blades can cause
severe injury. Stop the motor and ensure
that fan blades have stopped rotating
before opening the vacuum door, installing
or changing tubes, or opening or removing
the debris bag.
5
Original Instructions
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR