Installing The Wire Guard; With The Models Lp3M And Lp3S Strobe Light - Federal Signal LP3G Instrucciones De Instalación

Installing the Wire Guard

The Model LP3G Wire Guard is used with the Models LP3M, LP3S,
LP3T surface mounted strobe lights. These instructions supplement,
and do not replace, the installation instructions for each of these
models. Before installing the wire guard, follow the installation
instructions included with the strobe light. Installer-supplied #10 (5 mm)
screws of the appropriate length are required to mount the wire guard.

With the Models LP3M and LP3S Strobe Light

The wire guard for Models LP3M and LP3S includes two rubber
washers (Figure 2 on page 4 and Figure 3 on page 5). For
instructions on mounting and wiring the strobe light, see doc. No.
2561531 (LP3M) or doc. No. 2561456 (LP3S and LP3T).
To install the wire guard over the light:
1. If the strobe light is already installed, remove the light to avoid
damaging it when drilling holes for the wire guard.
2. To mark the locations of the mounting holes, use the wire
guard as a template or use the dimensions shown in Figure 1
on page 3.
3. Drill or punch out the holes marked on the mounting surface.
4. Mount the strobe light according the instructions included with
it (doc. No. 2561531 or 2561456).
5. Center a rubber washer, included with the wire guard, on each
mounting hole (Figures 1 and 2).
6. If wires are routed through the side of the strobe light, route
them through the wire guard.
7. Place the wire guard on the rubber washers and align the
mounting holes.
8. Secure the wire guard to the mounting location with user-
supplied #10 (5 mm) screws of the appropriate length.
9. Complete the wiring according to the instructions included
with the LP3M or LP3S strobe light.
1