Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SIMPLE™ KEY USER GUIDE
**If your FCC ID is OHT692713AA, use activation code noted with an asterisk** for
your vehicle's make, model, year, and button configuration. To check your key's
FCC ID, turn your key over. The FCC ID is engraved on the back of the remote.
Visit CKESimpleKey.com for the most up-to-date vehicle compatibility lookup.
STEP 1 (OF 2) KEY ACTIVATION
Follow the steps below to ACTIVATE your new key. Once you have activated your key, follow STEP 2 (of 2) KEY
PAIRING to pair the key to your vehicle.
1.
First, simultaneously press the LOCK and PANIC buttons on the remote. The light under the PANIC button will
illuminate and stay on.
2.
Using your ACTIVATION CODE found in the chart on pages 4 - 7, enter the first digit using the LOCK button, the
second digit using the PANIC button, and the third digit using the UNLOCK button.
For example, KEY CODE 314 is entered by pressing the LOCK button three (3) times, the PANIC button one
(1) time, and then the UNLOCK button four (4) times.
3.
Now, simultaneously press the LOCK and PANIC buttons on the remote.
a.
The light will now blink back the ACTIVATION CODE you originally entered. If this does not match, go
back to Step 1 to start over.
8
For example, the indicator light for KEY CODE 314 will blink (3) times, pause, blink one (1) time, pause, and
finally blink four (4) times.
b. If the light blinks rapidly this indicates an error. Go back to ACTIVATION step 1 and retry the steps using your
ACTIVATION CODE.
NOTE: You may re-enter activation codes anytime before the key is paired to your vehicle. After the key
Remote Back.
is paired to your vehicle, do not attempt to re-enter or change the button code. This will cause the key to
not work.
4.
Move on to STEP 2 (of 2) below to PAIR the remote to your vehicle.
Instructions have timing requirements. If you wait too long between steps, your vehicle's computer may time out,
requiring you to start over. Once you begin the pairing procedure, move at a quick and even pace.
NOTE: If the EZ Installer™ is left in the vehicle's on-board diagnostic (OBD) port for more than 5 minutes, an alarm will
sound reminding you to remove it.
NOTE: If at any point the EZ Installer™ continues to beep rapidly, please refer to the FAQ section for more information.
1.
Find your vehicle's make, model, and year in the Compatibility Lookup on pages 4 - 7. Turn the dial on the EZ
Installer™ to the position listed for your vehicle's make, model, and year.
NOTE: If more than 1 dial position exists for your vehicle, try the PRIMARY dial position first. If you are unable
to successfully pair the key, try the ALTERNATE dial position listed for your vehicle.
NOTE: One working key and the new key should be present during the pairing process.
2.
Enter the vehicle and ensure all doors are closed.
SIMPLE™ KEY USER GUIDE
STEP 2 (OF 2) KEY PAIRING
9
Publicidad
Tabla de contenido
