230V - Clarke FM-1500HD Libro De Instrucciones

PIN EARTHING CONTACT
Schuko Plug
SIDE EARTHING CONTACTS
Figure 6
Clavija de puesta a tierra
Enchufe Schuko
Muescas laterales para puesta a tierra
Figure 6a
Broche de mise à la terre
Fiche Schuko
Encoches latérales pour mise à la terre
Figure 6b
Page 14
230 VOLT MACHINES
Instruction for connection to the power
supply and the electrical ground
CAUTION: This machine will operate only
on the AC frequency and electrical volt-
age shown on the nameplate. Make sure
you have the correct frequency and volt-
age before connecting the power cord to
an outlet.
This machine must be connected to the electrical
ground to protect the operator from electric shock.
The machine has a power cord with two main conduc-
tors and one earthing conductor. Connect the plug to
the type of receptacle shown in figure 6. The green
and yellow conductor in the cord is the ground wire.
Never connect this wire to any terminal other than the
ground terminal.
WARNING: Always use this machine with
an AC three-conductor electrical system
connected to the electrical ground.
Replace any worn, cut, or damaged cords.
Replace any damaged plugs, receptacles,
or connector bodies. Do not move the
machine over an electrical cord. Always
lift the cord over the machine.
EXTENSION CORDS
Use only an approved extension cord with two main
conductors and one earthing conductor. The
machine has a power cord with wire size 1.5 mm
WARNING: If you use an extension cord,
use an extension cord with minimum wire
size 1.5mm
cord longer than 15 meters. Do not join
two extension cords.
WARNING: Do not cut, remove, or break
the ground terminal. Do not try to fit a
three- terminal plug into a receptacle or
connector body that does not fit the plug.
If the receptacle or comnnector body does
not fit the plug, see your Authorized
person to make the connection.
Clarke ® Operator's Manual FM-1500HD, 1700HD, 2000, & 2300
.
2 . Do not use an extension
2 .