Accessories; Maintenance; Lubrication; Motor And Gears - Clarke FM-1500HD Libro De Instrucciones

Ocultar thumbs Ver también para FM-1500HD:
Tabla de contenido

Publicidad

ACCESSORIES

These different brushes and attachments are avail-
able for the Model FM Floor Maintainer:
1. Brushes with natural or synthetic bristles for
polishing.
2. Brushes with natural or synthetic bristles for
scrubbing.
3. Brushes with steel wire bristles.
4. Synthetic pad holders.
5. Synthetic pads for polishing, scrubbing, strip-
ping, etc.
6. Lambs wool polishing pads.
7. Brushes with metal or wood backs, and with
holes to let the solution go through.
8. Solution tank.
9. Attachments for spray buffing.
10. Sanding, grinding, and carpet scrubbing ac-
cessories.
DANGER: Fine dust from a floor sanding
operation can cause an explo-
sion. Use a floor sanding ma-
chine only in anarea with good
ventilation.
For more information, see your dealer or the nearest
Clarke branch.
MAINTENANCE OF THE MACHINE
WARNING: Maintenance must be done by
authorized personnel only.
Clean your machine frequently. It will have longer
life and need fewer repairs.

Lubrication

The Polisher is completely lubricated. The bearings
and gears in the gear unit have enough lubricant for
two or three years of normal operation. All other
bearings are sealed and have enough lubricant for
the life of the machine.

Motor And Gears

Remove or blow dust and dirt from the motor
frequently.

Repairs

If repairs to the gear unit or motor are needed, do not
disassemble the gears and motor! Return the ma-
chine to the nearest Clarke Service Branch or Clarke
Authorized Service Center.
Page 18

Maintenance Inspection

Return the machine to a Clarke Authorized Service
location every 12 months for maintenance inspec-
tions.

Lever To Lock The Handle

The locking mechanism for the handle can become
loose. Tighten the nut on the end of the cross link bolt.
The pressure of the locking lever is correct when the
handle can be adjusted easily and fastened as needed.

Maintenance Of Brushes

Always remove the brush from the machine when not
in use. Keep brushes in a cool, dry location. Heat can
damage the wood and the bristles. Scrub brushes
with bassine fibers must be put in water for 16 hours
to replace moisture and give the bristles a longer life.
Clarke
®
Operator's Manual FM-1500HD, 1700HD, 2000, & 2300

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Fm-1700hdFm-2000Fm-2300

Tabla de contenido