Twin-Star International 23FM2590 Instrucciones De Ensamblaje página 5

PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to
assemble, install or operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 60 Minutes
Tools Required for Assembly (not included): Phillips head screwdriver, scissors and utility knife
ASSEMBLY INSTRUCTIONS
1. Attach Euro Hinge (GG) to the Right Front Door (M)
and Left Front Door (L) using a Phillips head
screwdriver to tighten the Wood Screw (HH) through
the pre-drilled holes.
Hardware Used
GG Euro Hinge
HH
Screw
2. Locate Center Left Side panel (B), Center Right Side
Panel (C), Center Front Panel (I) and Center Shelf
(D).
Insert one Wood Dowel (CC) into each of the
pre-drilled holes.
Push the Center Left Side Panel (B) and Center
Right Side Panel (C) snug to the Center Front Panel
(I) and Center Shelf (D). Make sure the Wood
Dowels (CC) are seated in the pre-drilled holes.
Then use Bolts (AA) and Washers (BB) through the
pre-drilled holes in the mounting blocks.
Connect the Center Left Side Panel (B), Center
Right Side Panel (C) and Center Front Panel (I)
with Connection Plate, tighten Screws (EE)
through the pre-drilled holes.
HAND TIGHTEN ONLY.
Hardware Used
AA
Bolt
BB
Washer
CC Wood Dowel
EE
Screw
Fig. 1
x 4
x 8
Fig. 2
EE
C
x 4
x 4
x 8
x 2
4
GG
HH
L
I
EE
D
BB
AA
M
B
CC