Twin-Star International 23FM2590 Instrucciones De Ensamblaje página 7

6. Locate Right Front Door (M) and Left Front Door (L).
Slide Euro Hinge (GG) into Euro Hinge bracket,
push the hinge until it clicks into place as shown in
Fig. 6 - 1.
Attach Knob (FF) to the Drawers and Doors, use the
bolts through the pre-drilled holes as shown in Fig.
6 - 2. Use a Phillips Head Screwdriver to tighten the
bolts. Knob (FF) maybe located inside the drawer.
Unscrew the bolt and reverse it's location.
Locate Drawer (K), extend the glides from the
completed assembly and align the metal tracks on
the left and right of Drawer (K). Make sure Drawer
(K) is aligned and centered in the cabinet, then
gently push the Drawer (K) into place.
CAUTION: Do not force the drawer into place, as
the cabinet might be damaged as a result.
Hardware Used
FF
Knob
7. To adjust door forward or backward:
Loosen screw A change keyhole slot position.
To adjust door right or left:
Turn screw B counter-clockwise to move door right,
clockwise to move door left.
To adjust door up or down:
Loosen screw C, adjust bracket height.
8. Choose desired height of Shelf (H) and place the
four Shelf Pin (DD) into same height shelf holes
inside side panels. Insert Wood Shelf (H), allow
Wood Shelf (H) to rest on the Shelf Pin (DD).
The Mantel must be level for the proper functionality
of doors and as a safety precaution. There are
levelers located under the mantel, the height can be
increased by twisting counter-clockwise.
Hardware Used
DD Shelf Pin
Fig. 6
L
x 8
Fig. 7
Fig. 8
x 8
6
M
K
A
B
C
H
DD
FF
leveler