In Case Of Difficulty - Ameriphone ALERTMASTER AM-100 Guía De Usuario

In Case of Difficulty

In case of difficulty, review the "Symptom and Remedy" list below.
Make sure no part of the Alertmaster system is on or near metal
surfaces or electrical equipment. Should the difficulty persist,
contact Ameriphone or your authorized dealer for assistance.
WARNING! DO NOT open the unit. You may be exposed to
hazardous high voltage electricity.
RESET/LAMP CONTROL
button doesn't work
Phone rings,
lamp doesn't flash
Door bell doesn't work
14
All manuals and user guides at all-guides.com
Symptom Cause and Remedy
Lamp is not turned on prior to
plugging it into Alertmaster.
Replace bulb if necessary.
Check all phone line connections.
Make sure you can turn the lamp
on or off with the lamp control
button on the AM-100 console.
Dead battery. Depress door bell
button, red indicator light should
light up. Replace if necessary.
The DIP switches may be
incorrectly set. See section on
"Channel Setting".
It may be out of range. Make
sure door bell is within a range
of 80 feet of the AM-100 base
unit.