REMOTE CONTROL LOCK
1. Press and hold the + and - buttons simultaneously to activate the remote control
child lock and prevent inadvertent changes to unit settings.
2. Press the + and - buttons simultaneously to deactivate the remote control lock.
CHANGE TEMPERATURE UNITS (C° OR F°)
While the unit is off, press the - and MODE button simultaneously on the remote
control to toggle the unit readout temperature between Celsius (C°) and Fahren-
heit (F°).
REPLACING THE REMOTE CONTROL UNIT BATTERIES
1. Press gently on the tab located on the back side of the remote control unit. Lift out
the battery compartment cover.
2. Replace the batteries with two AAA 1.5v batteries. Insert batteries while respecting
the polarity of the batteries (+ and - sides). Replace both batteries at the same
time; never insert an old battery with a fresh battery to avoid a battery leak.
3. Gently reinsert the battery compartment cover.
REMOTE CONTROL OPERATION NOTES
•
When using the remote control, aim the controller directly at the air conditioning
units IR receiver located on the control panel.
•
The remote control must have a clear line of sight to the control panel.
•
Interference to remote control operation may occur in areas with fluorescent light-
ing or wireless telephones.
•
When the remote control will remain unused for long periods of time, please re-
move the batteries.
•
If the display appears faint or does not appear, please replace the batteries.
PRE-INSTALLATION INSTRUCTIONS
TOOLS & ACCESSORIES FOR INSTALLATION
Gather the following tools and unit accessories before beginning your installation:
UNIT & ACCESSORIES
•
Air conditioning unit
•
Connectors A, B, C
•
Window frame (3 pieces)
•
Heat exhaust duct
•
Screws (x5)
•
Pipe clip
Note: Never use an underrated electrical cord or outlet!
•
Rubber stopper
•
Drainage pipe
•
Pipe hoop
•
Remote control batteries (2x AAA)
•
Remote control
•
Users manual
–6–